Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly

for Preparation Click here


DESCRIPTION

This is the display signal circuit between the navigation receiver assembly and the television camera assembly.

WIRING DIAGRAM


E160655E01


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION CAMERA ASSEMBLY)


    E160638E01
  1. Disconnect the I7 navigation receiver assembly connector.

  1. Disconnect the V17 television camera assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I7-22 (V+) - V17-2 (CV+)
    Always
    Below 1 Ω
    I7-23 (V-) - V17-1 (CV-)
    I7-21 (CGND) - V17-3 (CGND)
    I7-24 (CA+) - V17-4 (CB+)
    I7-22 (V+) - Body ground
    Always
    10 kΩ or higher
    I7-23 (V-) - Body ground
    I7-21 (CGND) - Body ground
    I7-24 (CA+) - Body ground

  1. Reconnect the navigation receiver assembly connector.

  1. Reconnect the television camera assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NAVIGATION RECEIVER ASSEMBLY


    E160639E01
  1. Disconnect the V17 television camera assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    V17-4 (CB+) - V17-3 (CGND)
    Ignition switch ON, shift lever in R
    5.5 to 7.05 V

  1. Reconnect the television camera assembly connector.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK


3.INSPECT TELEVISION CAMERA ASSEMBLY


    E160640E01
  1. Using an oscilloscope, check the waveform.
    Reference 
    Tester Connection
    V17-2 (CV+) - V17-1 (CV-)
    Tester Range
    0.2 V/DIV., 0.2 μsec./DIV.
    Vehicle Condition
    Ignition switch ON, shift lever R position

    OK:
    Waveform is as shown in the illustration.



NG
REPLACE TELEVISION CAMERA ASSEMBLY (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)