Home › Vehicle Interior › SEAT › REAR POWER SEAT CONTROL SYSTEM

REAR POWER SEAT CONTROL SYSTEM > Park / Neutral Position Switch Circuit

for Preparation Click here


DESCRIPTION

The fold seat control ECU receives signals from the Park/Neutral position switch and controls the seat folding and return operations. The shift lever is in any position other than P when the ignition switch is ON, the seat cannot be operated.

WIRING DIAGRAM


B193666E01


INSPECTION PROCEDURE

1.CHECK FOLD SEAT CONTROL ECU (PARK/NEUTRAL POSITION SWITCH SIGNAL)


    B193667E01
  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    LH Side 
    Tester Connection
    Condition
    Specified Condition
    O34-32 (P) - body ground
    Ignition switch ON
    Park/Neutral position switch P position
    11 to 14 V
    Ignition switch ON
    Park/Neutral position switch not in P position
    Below 1 V
    RH Side 
    Tester Connection
    Condition
    Specified Condition
    P20-32 (P) - body ground
    Ignition switch ON
    Park/Neutral position switch P position
    11 to 14 V
    Ignition switch ON
    Park/Neutral position switch not in P position
    Below 1 V



NG
Go to step 2
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

2.CHECK HARNESS AND CONNECTOR (PARK/NEUTRAL POSITION SWITCH - IGNITION SWITCH)


    C159064E18
  1. Disconnect the D21 switch connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    D21-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V
    Ignition switch off
    Below 1 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARK/NEUTRAL POSITION SWITCH


    C160109E16
  1. Disconnect the D21 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    2 (RB) - 6 (PL)
    4 (B) - 5 (L)
    Shift lever in P
    Below 1 Ω
    2 (RB) - 6 (PL)
    4 (B) - 5 (L)
    Shift lever not in P
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (A750E automatic transmission)
    B
    NG (A750F automatic transmission)
    C
    NG (AB60E automatic transmission)
    D
    NG (AB60F automatic transmission)
    E



B
REPLACE PARK/NEUTRAL POSITION SWITCH (Click here)

C
REPLACE PARK/NEUTRAL POSITION SWITCH (Click here)

D
REPLACE PARK/NEUTRAL POSITION SWITCH (Click here)

E
REPLACE PARK/NEUTRAL POSITION SWITCH (Click here)
A

REPAIR OR REPLACE HARNESS OR CONNECTOR (FOLD SEAT CONTROL ECU - PARK/NEUTRAL POSITION SWITCH)