AUDIO AND VISUAL SYSTEM > Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter |

| 1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO JACK ADAPTER ASSEMBLY) |
![]() |
Disconnect the I3 radio receiver assembly connector.
Disconnect the H7 stereo jack adapter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| I3-17 (ALI) - H7-1 (ALO) | Always | Below 1 Ω |
| I3-15 (ARI) - H7-2 (ARO) | ||
| I3-16 (ASGN) - H7-3 (ASGN) | ||
| I3-18 (AUXG) - H7-5 (AUXG) | ||
| I3-19 (AUXI) - H7-4 (AUXO) | ||
| I3-17 (ALI) - Body ground | Always | 10 kΩ or higher |
| I3-15 (ARI) - Body ground | ||
| I3-16 (ASGN) - Body ground | ||
| I3-19 (AUXI) - Body ground |
Reconnect the radio receiver assembly connector.
Reconnect the stereo jack adapter assembly connector.
|
| ||||
| OK | ||
| ||