Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Rear Door)

BLACK OUT TAPE (for Rear Door) > INSTALLATION

for Preparation Click here



1. INSTALL NO. 2 BLACK OUT TAPE
  1. Application precautions .

  1. Clean the attachment surface (using an infrared light) .

  1. Clean the attachment surface (using a tape removal disc) .



  1. Apply new No. 2 black out tape to the positions shown in the illustration.


    B191715E01

    Installation Position:
    Mark
    Measurement
    a
    2.0 mm (0.079 in.)
    b
    3.0 mm (0.118 in.)
    c
    1.0 or less (0.039 or less in.)



2. INSTALL REAR DOOR GLASS RUN

HINT:
Use the same procedure as for the RH side .



3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



4. INSTALL REAR DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the RH side .



5. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

HINT:
Use the same procedure as for the RH side .



6. INSTALL REAR DOOR FRAME GARNISH

HINT:
Use the same procedure as for the RH side .



7. INSTALL REAR DOOR GLASS OUTER WEATHERSTRIP


B191705
  1. Engage the 5 claws and clip and install a new rear door glass outer weatherstrip.



8. INSTALL REAR DOOR WINDOW FRAME REAR MOULDING
  1. Apply Primer G to the installation part of rear door window frame rear moulding.

    NOTICE:
    1. Allow the primer to dry for 3 minutes or more.
    2. Throw away any leftover Primer G.
    3. Do not apply too much Primer G.

  1. Remove the release paper from the rear door window frame rear moulding.



    B191717
  1. Engage the claw and clip and install the rear door window frame rear moulding.