Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › BLACK OUT TAPE (for Rear Door)

BLACK OUT TAPE (for Rear Door) > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the RH side and LH side.
  2. The procedure described below is for the LH side.



1. REMOVE REAR DOOR WINDOW FRAME REAR MOULDING


B191717
  1. Disengage the claw and clip and remove the rear door window frame rear moulding.

    NOTICE:
    Remove any tape remaining on the door panel side.



2. REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP


B191703E01
  1. Apply protective tape to the door panel in the area around the rear door glass outer weatherstrip.



    B191704E01
  1. Using a moulding remover, disengage the 5 claws and the clip and remove the rear door glass outer weatherstrip.



3. REMOVE REAR DOOR FRAME GARNISH

HINT:
Use the same procedure as for the RH side .



4. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

HINT:
Use the same procedure as for the RH side .



5. REMOVE REAR DOOR ARMREST BASE UPPER PANEL

HINT:
Use the same procedure as for the RH side .



6. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

HINT:
Use the same procedure as for the RH side .



7. REMOVE REAR DOOR GLASS RUN

HINT:
Use the same procedure as for the RH side .



8. REMOVE NO. 2 BLACK OUT TAPE


    B195427
  1. Using an infrared light, heat the No. 2 black out tape.

    CAUTION:
    Do not burn yourself on the hot rear door panel or with the infrared light.

    HINT:
    Heat at 40 to 60°C (104 to 140°F) for 3 to 5 minutes.

  1. Lift the end portion with your nail and peel it parallel to the attachment surface.