Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK THROTTLE BODY


    A153485
  1. Check the throttle control motor operating sounds.

    1. Turn the ignition switch to ON.

    2. When depressing the accelerator pedal, check the operating sound of the running motor. Make sure that no friction noises emit from the motor. If friction noise exists, replace the throttle body.

  1. Check the throttle position sensor.

    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON.

    3. Push the Techstream main switch ON.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Throttle Sensor Position.

    5. Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of the "THROTTLE POS (Throttle Sensor Position)" is within the specification.

      Standard throttle valve opening percentage:
      60% or more

      HINT:
      When checking the standard throttle valve opening percentage, the shift lever should be in N.

      If the percentage is less than 60%, replace the throttle body.