FUEL SYSTEM > ON-VEHICLE INSPECTION |
| 1. CHECK FUEL PUMP OPERATION AND FUEL LEAK |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream ON.
Techstream:
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.
![]() |
Check that the pulsation damper screw rises up when the fuel pump operates.
If the operation is not as specified, check the following parts:
Turn the ignition switch off.
Disconnect the Techstream from the DLC3.
| 2. CHECK FUEL PRESSURE |
Check that the battery voltage is 11 to 14 V.
Discharge fuel system pressure (Click here).
Disconnect the negative (-) terminal cable from the battery.
Remove the front fuel pipe from the LH delivery pipe .
![]() |
Install the front fuel pipe and SST (pressure gauge) to the delivery pipe with the 3 gaskets and another SST (adapter).
Wipe off any splattered gasoline.
Reconnect the cable to the negative (-) battery terminal.
Connect the Techstream to the DLC3 (refer to the "Check Fuel Pump Operation and Fuel Leak" procedure).
Measure the fuel pressure.
Disconnect the Techstream from the DLC3.
Start the engine.
Measure the fuel pressure at idle.
Stop the engine.
Check that the fuel pressure remains as specified for 5 minutes after the engine has stopped.
After checking the fuel pressure, disconnect the cable from the negative (-) battery terminal and carefully remove SST to prevent gasoline from splashing.
Reinstall the front fuel pipe to the LH delivery pipe .
Reconnect the negative (-) terminal cable to the battery.
Check for fuel leaks (refer to the "Check Fuel Pump Operation and Fuel Leak" procedure).