REAR AIR CONDITIONING UNIT > DISASSEMBLY |
| 1. REMOVE REAR AIR MIX DAMPER SERVO MOTOR SUB-ASSEMBLY |
![]() |
Disconnect the connector.
Remove the 2 screws and rear air mix control servo motor.
| 2. REMOVE REAR MODE DAMPER SERVO MOTOR SUB-ASSEMBLY |
![]() |
Remove the 4 screws and the bracket.
![]() |
Disconnect the connector.
Remove the 2 screws and rear mode damper servo motor.
| 3. REMOVE AIR CONDITIONING CONNECTOR TUBE |
![]() |
Remove the packing.
![]() |
Disconnect the hose.
Remove the 3 screws.
![]() |
Remove the bolt and slide the hook connector.
Remove the air conditioning connector tube.
![]() |
Remove the 2 O-rings from the air conditioning connector tube.
| 4. REMOVE WATER PIPE SUB-ASSEMBLY |
![]() |
Remove the 4 screws and the bracket.
![]() |
Using pliers, grip the claws of the 2 clips and side the clips to remove the water pipe.
| 5. REMOVE HEATER INLET WATER HOSE |
![]() |
Disengage the claw and separate the clamp.
Using pliers, grip the claws of the clip and slide the clips to disconnect the heater water hose.
| 6. REMOVE HEATER OUTLET WATER HOSE |
![]() |
Using pliers, grip the claws of the clip and slide the clips to disconnect the heater water hose.
| 7. REMOVE HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Remove the screw.
Disengage the claw and remove the heater clamp.
![]() |
Remove the heater radiator unit from the rear cooling unit as shown in the illustration.
| 8. REMOVE REAR BLOWER MOTOR SUB-ASSEMBLY |
![]() |
Remove the 3 screws and the rear blower motor.
| 9. REMOVE BLOWER MOTOR CONTROL |
![]() |
Remove the 2 screws and the blower motor controller.
| 10. REMOVE REAR COOLING UNIT EXPANSION VALVE |
![]() |
Disengage the 3 claws and remove the plate.
![]() |
Remove the grommet.
![]() |
Using a 4 mm hexagon wrench, remove the 2 hexagon bolts and rear cooling unit expansion valve.
| 11. REMOVE REAR EVAPORATOR TEMPERATURE SENSOR |
![]() |
Disengage the clamp.
Disengage the claw and the rear evaporator temperature sensor.
| 12. REMOVE REAR EVAPORATOR SUB-ASSEMBLY |
![]() |
Remove the 13 screws.
![]() |
Remove the rear evaporator as shown in the illustration.
![]() |
Remove the 2 O-rings from the rear evaporator.