REAR AIR CONDITIONING UNIT > REASSEMBLY |
| 1. INSTALL REAR EVAPORATOR SUB-ASSEMBLY |
![]() |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces.
Install the 2 O-rings to the rear evaporator.
![]() |
Install the rear evaporator as shown in the illustration.
![]() |
Install the 13 screws.
| 2. INSTALL REAR EVAPORATOR TEMPERATURE SENSOR |
![]() |
Engage the claw and install the rear evaporator temperature sensor.
Engage the clamp to the rear cooling unit.
| 3. INSTALL REAR COOLING UNIT EXPANSION VALVE |
![]() |
Using a 4 mm hexagon wrench, install the rear cooling unit expansion valve with the 2 hexagon bolts.
![]() |
Install the grommet.
![]() |
Engage the 3 claws and install the plate.
| 4. INSTALL BLOWER MOTOR CONTROL |
![]() |
Install the blower motor controller with the 2 screws.
| 5. INSTALL REAR BLOWER MOTOR SUB-ASSEMBLY |
![]() |
Install the rear blower motor with the 3 screws.
| 6. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY |
![]() |
Install the heater radiator unit as shown in the illustration.
![]() |
Engage the claw and install the heater clamp.
Install the heater clamp with the screw.
| 7. INSTALL HEATER OUTLET WATER HOSE |
![]() |
Using pliers, grip the claws of the clip and slide the clips to connect the heater water hose.
| 8. INSTALL HEATER INLET WATER HOSE |
![]() |
Using pliers, grip the claws of the clip and slide the clips to connect the heater water hose.
Engage the claw and install the clamp.
| 9. INSTALL WATER PIPE SUB-ASSEMBLY |
![]() |
Using pliers, grip the claws of the 2 clips and slide the clips to install the water pipe.
![]() |
Install the bracket with the 4 screws.
| 10. INSTALL AIR CONDITIONING CONNECTOR TUBE |
Sufficiently apply compressor oil to 2 new O-rings and the fitting surfaces of the air conditioning connector tube.
![]() |
Install the 2 new O-rings on the air conditioning connector tube.
![]() |
Move the hook connector in the direction indicated by the arrow in the illustration.
Insert the pipe joint into the fitting hole securely and tighten the bolt.
![]() |
Install the air conditioning connector tube with the 3 screws.
Connect the hose.
![]() |
Install the packing.
| 11. INSTALL REAR MODE DAMPER SERVO MOTOR SUB-ASSEMBLY |
![]() |
Using the reference point, install the rear mode damper servo motor with the 2 screws.
Connect the connector.
![]() |
Install the bracket with the 4 screws.
| 12. INSTALL REAR AIR MIX DAMPER SERVO MOTOR SUB-ASSEMBLY |
![]() |
Using the reference point, install the rear air mix control servo motor with the 2 screws.
Connect the connector.