Home › Engine / Hybrid System · 2UZ-FE › EMISSION CONTROL › PURGE VALVE

PURGE VALVE > INSPECTION

for Preparation Click here



1. INSPECT PURGE VSV


A162424E02
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    23 to 26 Ω
    1 - Body ground
    Always
    10 MΩ or higher
    2 - Body ground

    If the result is not specified, replace the purge VSV.



    A153525E01
  1. Inspect the purge VSV operation.

    1. Check that air does not flow from ports.



    2. A153526E01
    3. Apply battery voltage across the terminals.

    4. Check that air flows from ports.
      If operation is not as specified, replace the purge VSV.