Home › Engine / Hybrid System ยท 2UZ-FE › EMISSION CONTROL › PCV VALVE

PCV VALVE > INSPECTION

for Preparation Click here



1. INSPECT VENTILATION VALVE SUB-ASSEMBLY


    B016486E01
  1. Install a clean hose to the ventilation valve sub-assembly.



  1. Inspect the ventilation valve sub-assembly operation.

    1. Blow air into the cylinder head side, and check that air passes through smoothly.

      CAUTION:
      Do not suck air through the valve. Petroleum substances inside the valve are harmful.



    2. B016487E01
    3. Blow air into the intake manifold side, and check that air does not pass through smoothly.
      If operation is not as specified, replace the ventilation valve sub-assembly.

  1. Remove the clean hose from the ventilation valve sub-assembly.