Home › Vehicle Exterior › DOOR / HATCH › BACK DOOR CLOSER SYSTEM

DTC    B2250    Back Door Closer Operation Malfunction

for Preparation Click here


DESCRIPTION

The power back door ECU inputs signals from the full-latch switch, sector switch and back door courtesy light switch, which are built into the back door lock. Based on these switch signals, the latch position of the back door lock is determined.

DTC No.
DTC Detection Condition
Trouble Area
B2250
While back door closer is operating, malfunction is detected in position information from sector switch within specified amount of time
  1. Back door lock
  2. Harness or connector
  3. Power back door ECU

WIRING DIAGRAM


B189795E01


INSPECTION PROCEDURE

1.INSPECT BACK DOOR LOCK (SECTOR SWITCH)

B191744E01

  1. Remove the back door lock (Click here).

  1. Measure the resistance of the switch.

    Standard Resistance:
    Tester Connection
    Door Lock Latch Position
    Specified Condition
    3 (FSW) - 4 (E)
    Open-latch
    Below 1 Ω
    3 (FSW) - 4 (E)
    Over-latch
    10 kΩ or higher
    3 (FSW) - 4 (E)
    Full-latch
    10 kΩ or higher
    3 (FSW) - 4 (E)
    Half-latch
    10 kΩ or higher

  1. Reinstall the back door lock.



NG
REPLACE BACK DOOR LOCK (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (BACK DOOR LOCK - POWER BACK DOOR ECU AND BODY GROUND)


    B195706E01
  1. Disconnect the V5 door lock connector.

  1. Disconnect the O30 ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    V5-4 (FSW) - O30-24 (POS)
    Always
    Below 1 Ω
    V5-3 (E) - Body ground
    Always
    Below 1 Ω
    V5-4 (FSW) - Body ground
    Always
    10 kΩ or higher

  1. Reconnect the door lock and ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE POWER BACK DOOR DRIVE UNIT (POWER BACK DOOR ECU) (Click here)