DTC B2221 Jam Protection Pulse Sensor Circuit on Back Door |
| DTC Code | DTC Detection Condition | Suspected Part |
| B2221 |
|
|

| 1.PERFORM INITIALIZATION (BACK DOOR POWER WINDOW REGULATOR MOTOR) |
Initialize the back door power window regulator motor (Click here).
| NEXT | |
| 2.CHECK DTC |
Clear the DTC (Click here).
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK HARNESS AND CONNECTOR (BACK DOOR ECU - BACK DOOR POWER WINDOW REGULATOR MOTOR) |
![]() |
Disconnect the V3 back door ECU connector.
Disconnect the V4 back door power window regulator motor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| V3-12 (DSV) - V4-4 (SSRB) | Always | Below 1 Ω |
| V3-13 (DS1) - V4-3 (PLS1) | Always | Below 1 Ω |
| V3-14 (DS2) - V4-5 (PLS2) | Always | Below 1 Ω |
| V3-23 (DSG) - V4-6 (LMTE) | Always | Below 1 Ω |
| V3-12 (DSV) - Body ground | Always | 10 kΩ or higher |
| V3-13 (DS1) - Body ground | Always | 10 kΩ or higher |
| V3-14 (DS2) - Body ground | Always | 10 kΩ or higher |
| V3-23 (DSG) - Body ground | Always | 10 kΩ or higher |
Reconnect the back door power window regulator motor connector.
Reconnect the back door ECU connector.
|
| ||||
| OK | |
| 4.REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR |
Replace back door power window regulator motor .
| NEXT | |
| 5.CHECK DTC |
Clear the DTC (Click here).
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||