Home › Engine / Hybrid System ยท 2UZ-FE › LUBRICATION › ENGINE OIL COOLER

ENGINE OIL COOLER > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }



    A156211E01

  1. Tighten the radiator drain cock plug by hand.



3. DRAIN ENGINE OIL


    A150107
  1. Remove the oil filler cap.

  1. Remove the oil drain plug and gasket, and drain the engine oil into a container.

  1. Install a new gasket and the oil pan drain plug.

    Torque:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }



4. REMOVE OIL FILTER ASSEMBLY


    A150109E01
  1. Using SST, remove the oil filter.

    SST
    09228-07501  



5. REMOVE OIL COOLER ASSEMBLY


    A150132
  1. Disconnect the 2 oil cooler hoses from the oil cooler.

  1. Remove the union bolt, plate washer and oil cooler.



    A150134E01
  1. Remove the O-ring from the oil cooler.