Home › Engine / Hybrid System ยท 3UR-FE › COOLING › THERMOSTAT

THERMOSTAT > REMOVAL

for Preparation Click here


HINT:
If the thermostat was not installed, cooling efficiency would decrease. Even if the engine tends to overheat, do not remove the thermostat.



1. REMOVE V-BANK COVER SUB-ASSEMBLY


A165576E03
  1. Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.



2. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



3. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

HINT:
Collect the coolant in a container and dispose of it according to the regulations in your area.

  1. Loosen the radiator drain cock plug.

  1. Remove the radiator cap. Then drain the coolant from the radiator.

  1. Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    A151835E01

  1. Tighten the radiator drain cock plug by hand.



4. DISCONNECT NO. 3 AIR INJECTION SYSTEM HOSE


    A183217
  1. Disconnect the No. 3 air injection hose.



5. DISCONNECT NO. 2 AIR INJECTION SYSTEM HOSE


    A183219
  1. Disconnect the connector and separate the wire harness clamp.

  1. Disconnect the No. 2 air injection hose.



6. SEPARATE AIR PIPE SUB-ASSEMBLY


    A183221
  1. Disconnect the connector and separate the 2 clamps and wire harness.

  1. Remove bolt and separate the air pipe.



7. DISCONNECT OUTLET RADIATOR HOSE


    A183247
  1. Disconnect the outlet radiator hose from the water inlet housing.



8. DISCONNECT NO. 5 WATER BY-PASS HOSE


    A183224
  1. Disconnect the No. 5 water by-pass hose.



9. REMOVE INLET WATER SUB-ASSEMBLY WITH THERMOSTAT


    A151841
  1. Remove the 3 nuts, water inlet with thermostat and gasket.