Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Park / Neutral Position Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit sends the park/neutral position switch signals to the clearance warning ECU.

WIRING DIAGRAM


B144584E03


INSPECTION PROCEDURE

1.INSPECT PARK / NEUTRAL POSITION SWITCH


    E146355E02
  1. Disconnect the D21 park/neutral position switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Condition
    Condition
    Specified Condition
    6 (PL) - 2 (RB)
    Shift lever in P
    Below 1 Ω
    1 (RL) - 2 (RB)
    Shift lever in R
    Below 1 Ω
    6 (PL) - 2 (RB)
    Shift lever not in P
    10 kΩ or higher
    1 (RL) - 2 (RB)
    Shift lever not in R
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (for A750E)
    B
    NG (for A750F)
    C
    NG (for AB60E)
    D
    NG (for AB60F)
    E

  1. Reconnect the park/neutral position switch connector.



B
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)

C
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)

D
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)

E
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)
A


2.CHECK HARNESS AND CONNECTOR (SWITCH - CLEARANCE WARNING ECU - BATTERY AND BODY GROUND)


    B144078E03
  1. Disconnect the D21 park/neutral position switch connector.

  1. Disconnect the H43 clearance warning ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Condition
    Switch Condition
    Specified Condition
    D21-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Condition
    Condition
    Specified Condition
    D21-6 (PL) - H43-1 (PL)
    Always
    Below 1 Ω
    D21-1 (RL) - H43-13 (RL)
    D21-6 (PL) - Body ground
    Always
    10 kΩ or higher
    D21-1 (RL) - Body ground

  1. Reconnect the park/neutral position switch connector.

  1. Reconnect the clearance warning ECU connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)