Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Front Clearance Sonar Sensor LH Circuit

for Preparation Click here


DESCRIPTION

The ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU.

WIRING DIAGRAM


E132021E16


INSPECTION PROCEDURE

1.REPLACE FRONT CORNER NO. 1 ULTRASONIC SENSOR LH
  1. Replace the front corner No. 1 ultrasonic sensor with a normally functioning sensor (Click here).


NEXT


2.CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR LH - FRONT CORNER SENSOR RH)


    B144572E26
  1. Disconnect the C1 and B1 front corner No. 1 ultrasonic sensor connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    C1-1 (BI) - B1-2 (BO)
    Always
    Below 1 Ω
    C1-3 (SI) - B1-4 (SO)
    C1-5 (EI) - B1-6 (EO)
    C1-1 (BI) - Body ground
    Always
    10 kΩ or higher
    C1-3 (SI) - Body ground
    C1-5 (EI) - Body ground

  1. Reconnect the front corner No. 1 ultrasonic sensor connectors.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)