PARK / NEUTRAL POSITION SWITCH > INSPECTION |
| 1. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 2 (RB) - 5 (PL) | Shift Position P | Below 1 Ω |
| 2 (RB) - 5 (PL) | Shift Position Not P | 10 kΩ or higher |
| 2 (RB) - 1 (RL) | Shift Position R | Below 1 Ω |
| 2 (RB) - 1 (RL) | Shift Position Not R | 10 kΩ or higher |
| 2 (RB) - 7 (NL) | Shift Position N | Below 1 Ω |
| 2 (RB) - 7 (NL) | Shift Position Not on N | 10 kΩ or higher |
| 2 (RB) - 6 (DL) | Shift Position D and S | Below 1 Ω |
| 2 (RB) - 6 (DL) | Shift Position Not D and S | 10 kΩ or higher |
| 3 (B) - 4 (L) | Shift Position P and N | Below 1 Ω |
| 3 (B) - 4 (L) | Shift Position Not P and N | 10 kΩ or higher |