Home › Engine / Hybrid System ยท 3UR-FE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > INSTALLATION

for Preparation Click here



1. INSTALL ENGINE REAR OIL SEAL
  1. Apply MP grease to the lip of a new oil seal.



    A163777E01
  1. Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.

    SST
    09223-56010  

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap on the oil seal at an angle.



2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A163778E01
  1. Using SST, hold the crankshaft.

    SST
    09213-70011  
    09330-00021  

  1. Install the crankshaft angle sensor plate, drive gear and rear drive plate spacer to the crankshaft.



    A163779E01
  1. Install and uniformly tighten 10 new bolts in the sequence shown in the illustration.

    Torque:
    30 N*m{ 301 kgf*cm , 22 ft.*lbf }

    NOTICE:
    1. Do not reuse the flywheel installation bolts.
    2. Do not strike or damage the flywheel installation bolts. Be sure to handle them carefully.



    A149106E01
  1. Mark the upside of each flywheel installation bolt with paint.

  1. Tighten the flywheel installation bolts another 90° as shown.

  1. Check that the painted marks are now at a 90° angle to the upside.



3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)
  1. Install the automatic transmission assembly (Click here).



4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 4WD)
  1. Install the automatic transmission assembly (Click here).