Home › Engine / Hybrid System ยท 2UZ-FE › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER DUST PROTECTOR
  1. Remove the 2 dust protectors.



2. REMOVE STARTER YOKE ASSEMBLY


    A159744
  1. Remove the nut and disconnect the lead wire from the magnetic switch terminal.

  1. Remove the 2 bolts.

  1. Pull out the starter yoke with the armature from the magnetic switch.

  1. Remove the O-ring from the starter yoke.



3. REMOVE STARTER CLUTCH SUB-ASSEMBLY


    A139613
  1. Remove the 2 screws.



    A159739E01
  1. Remove the return spring, idler gear, clutch roller, retainer, O-ring and starter clutch from the starter housing.



    ST00948E02
  1. Using a magnetic finger, remove the steel ball from the clutch shaft hole.



4. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    A159731
  1. Remove the 2 screws, 2 O-rings and end cover from the starter yoke.

  1. Remove the O-ring from the starter yoke.



    P010568
  1. Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.

  1. Disconnect the 4 brushes and remove the brush holder.



5. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.