IGNITION SWITCH > INSTALLATION |
| 1. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY |
![]() |
Attach the 2 claws to install the ignition or starter switch assembly.
![]() |
Connect the ignition or starter switch assembly connector.
| 2. INSTALL LOWER STEERING COLUMN COVER |
![]() |
Attach the 2 claws to install the steering column lower cover.
| 3. CUSTOMIZE INFORMATION (for Power Tilt and Power Telescopic Steering Column) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Utility / Customize Setting / Tilt & Telesco.
Turn the auto away/return function OFF.
Turn the ignition switch to ACC.
Operate the tilt and telescopic switch to fully raise the tilt and extend the steering wheel.
Turn the ignition switch OFF.