Home › Engine / Hybrid System ยท 3UR-FBE › STARTING › IGNITION SWITCH

IGNITION SWITCH > REMOVAL

for Preparation Click here



1. CUSTOMIZE INFORMATION (for Power Tilt and Power Telescopic Steering Column)
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Utility / Customize Setting / Tilt & Telesco.

  1. Turn the auto away/return function OFF.

  1. Turn the ignition switch to ACC.

  1. Operate the tilt and telescopic switch to fully raise the tilt and extend the steering wheel.

  1. Turn the ignition switch OFF.



2. REMOVE LOWER STEERING COLUMN COVER


C181134
  1. Remove the 2 screws.

  1. Detach the 2 claws to remove the lower steering column cover.



3. REMOVE IGNITION OR STARTER SWITCH ASSEMBLY


    A185678
  1. Disconnect the ignition or starter switch assembly connector.



    A185679
  1. Detach the 2 claws and remove the ignition or starter switch assembly.