Home › Audio/Visual/Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM

AUDIO AND VISUAL SYSTEM > Cellular Phone Voice Circuit between Radio Receiver and Stereo Component Amplifier

for Preparation Click here


SYSTEM DESCRIPTION

This circuit is used when the cellular phone voice in the "Bluetooth" handsfree system is on.

WIRING DIAGRAM


E146459E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER)


    E145926E02
  1. Disconnect the I3 radio receiver assembly connector.

  1. Disconnect the I17 stereo component amplifier assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I3-11 (IVO+) - I17-15 (II1+)
    Always
    Below 1 Ω
    I3-12 (IVO-) - I17-14 (II1-)
    I3-11 (IVO+) - Body ground
    Always
    10 kΩ or higher
    I3-12 (IVO-) - Body ground

  1. Reconnect the radio receiver assembly connector.

  1. Reconnect the stereo component amplifier assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)