Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR MAIN SWITCH

POWER BACK DOOR MAIN SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER BACK DOOR MAIN SWITCH


    B192518E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    6 (MSE) - 9 (MSW)
    Free
    Below 1 Ω
    6 (MSE) - 9 (MSW)
    Pushed
    10 kΩ or higher

    If the result is not as specified, replace the power back door main switch.



    B192519E01
  1. Check the illumination operation.

    1. Connect the positive (+) battery lead to terminal 8 (ILL+) and the negative (-) battery lead to terminal 7 (ILL-), then check that the illumination illuminates.

      OK:
      Illumination illuminates.

      If the result is not as specified, replace the power back door main switch.