Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE CONTROL › CRANKSHAFT POSITION SENSOR

CRANKSHAFT POSITION SENSOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



2. REMOVE CRANKSHAFT POSITION SENSOR


    A153483
  1. Disconnect the crankshaft position sensor connector.

  1. Remove the bolt and crankshaft position sensor.