STEERING SYSTEM > ADJUSTMENT |
| 1. STEERING OFF CENTER ADJUSTMENT PROCEDURE |
Inspect the steering wheel off center.
![]() |
Apply masking tape on the top center of the steering wheel and upper steering column cover.
Drive the vehicle in a straight line for 100 m (328 ft.) at a constant speed of 56 km/h (35 mph), and hold the steering wheel to maintain the course.
![]() |
Draw a line on the masking tape as shown in the illustration.
Turn the steering wheel to its straight position.
![]() |
Draw a new line on the masking tape of the steering wheel as shown in the illustration.
Measure the distance between the 2 lines on the masking tape of the steering wheel.
Convert the measured distance to steering angle.
Adjust the steering angle.
Lift up the vehicle.
Draw a line on the tie rod RH and LH and rack ends where it can easily be seen.
Using a paper gauge, measure the distance from the tie rod end RH and LH to the rack end screws.
![]() |
Remove the boot clip RH and LH from the rack boots.
Loosen the lock nut RH and LH.
Turn the rack end RH and LH by the same amount (but in different directions) according to the steering angle.
Tighten the lock nut RH and LH to the specified torque.
Install the boot clip RH and LH.