VANE PUMP (for 2UZ-FE) > DISASSEMBLY |
| 1. FIX VANE PUMP ASSEMBLY |
![]() |
Using SST, hold the vane pump in a vise.
| 2. REMOVE POWER STEERING SUCTION PORT UNION |
![]() |
Remove the bolt and suction port union from the vane pump.
Using a screwdriver, remove the O-ring from the suction port union.
| 3. REMOVE VANE PUMP REAR HOUSING |
![]() |
Remove the 4 bolts and rear housing from the front housing.
![]() |
Using a screwdriver, remove the O-ring from the rear housing.
| 4. REMOVE VANE PUMP SHAFT SUB-ASSEMBLY WITH PULLEY |
![]() |
Using 2 screwdrivers, remove the snap ring from the vane pump shaft.
Remove the vane pump shaft sub-assembly with pulley.
| 5. REMOVE VANE PUMP ROTOR |
![]() |
Remove the 10 vane plates.
Remove the vane pump rotor.
| 6. REMOVE VANE PUMP CAM RING |
![]() |
Remove the cam ring from the front housing.
| 7. REMOVE VANE PUMP FRONT SIDE PLATE |
![]() |
Remove the front side plate from the front housing.
![]() |
Using a screwdriver, remove the O-ring from the front side plate.
![]() |
Remove the O-ring from the front housing.
| 8. REMOVE VANE PUMP HOUSING OIL SEAL |
![]() |
Using a screwdriver and piece of cloth, pry out the oil seal.