Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP (for 2UZ-FE)

VANE PUMP (for 2UZ-FE) > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



2. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY


    A153486
  1. Remove the 2 nuts and throttle body cover sub-assembly.



3. REMOVE AIR CLEANER ASSEMBLY WITH AIR CLEANER HOSE


A185295
  1. Disconnect the air flow meter connector.

  1. Separate the wire harness.

  1. Disconnect the vacuum hose and No. 2 ventilation hose.

  1. Loosen the air cleaner hose clamp.

  1. Remove the 2 bolts and air cleaner with air cleaner hose assembly.



4. DRAIN POWER STEERING FLUID


5. REMOVE FAN AND GENERATOR V BELT


    B000809E02
  1. Loosen the belt tension by turning the belt tensioner counterclockwise, and then remove the fan and generator V belt.

    HINT:
    The pulley bolt for the belt tensioner has left-hand thread.



6. DISCONNECT NO. 1 OIL RESERVOIR TO PUMP HOSE


C181263
  1. Detach the clip and disconnect the hose.



7. DISCONNECT POWER STEERING OIL PRESSURE SENSOR CONNECTOR


C181264
  1. Disconnect the connector.



8. DISCONNECT SOLENOID VALVE CONNECTOR


C181265
  1. Disconnect the connector.



9. SEPARATE PRESSURE FEED TUBE


C181317
  1. Remove the bolt and separate the pressure feed tube.

  1. Remove the gasket.



10. REMOVE VANE PUMP ASSEMBLY


C181334
  1. Remove the 2 bolts, nut and vane pump assembly.