Home › Steering › STEERING GEAR / LINKAGE › STEERING GEAR

STEERING GEAR > REASSEMBLY

for Preparation Click here



1. FIX POWER STEERING GEAR ASSEMBLY


C181259E01
  1. Using SST, secure the power steering gear.

    SST
    09612-00012  

    HINT:
    Tape SST before use.

    NOTICE:
    When using a vise, do not overtighten it.



2. INSTALL NO. 2 STEERING RACK BOOT


C100988
  1. Apply silicon grease to the inside of the small opening of the boot.

  1. Install the No. 2 steering rack boot to the groove on the rack housing.

    NOTICE:
    Be careful not to damage or twist the boot.



3. INSTALL NO. 1 STEERING RACK BOOT

HINT:
Use the same procedure described for the No. 2 steering rack boot.



4. INSTALL NO. 2 STEERING RACK BOOT CLAMP


C124255E02
  1. Using SST, tighten the 2 new boot clamps as shown in the illustration.

    SST
    09521-24010  

    Standard clearance:
    3.0 mm (0.119 in.) or less

    NOTICE:
    Be careful not to damage the boot.



5. INSTALL STEERING RACK BOOT CLIP


C132523E03
  1. Using pliers, install the 2 boot clips.

    NOTICE:
    Make sure that each clip's claws are positioned within the area shown in the illustration.



6. INSTALL TIE ROD END SUB-ASSEMBLY LH


C154516E01
  1. Align the matchmarks of the tie rod and rack end, and temporarily install the tie rod with the lock nut.

    HINT:
    After adjusting toe-in, tighten the lock nut.

    Torque:
    82 N*m{ 836 kgf*cm , 61 ft.*lbf }



7. INSTALL TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedure for both sides.