Home › Engine / Hybrid System ยท 2UZ-FE › FUEL › FUEL PRESSURE REGULATOR

FUEL PRESSURE REGULATOR > INSTALLATION

for Preparation Click here



1. INSTALL FUEL PRESSURE REGULATOR ASSEMBLY


    A159726
  1. Apply a light coat of gasoline to a O-ring, and install it to the fuel pressure regulator assembly.

  1. While turning the fuel pressure regulator assembly to the left and right, install it to the delivery pipe.



    A159711
  1. Install the fuel pressure regulator assembly with the 2 bolts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the fuel hose to the fuel pressure regulator assembly.



    A159710
  1. Connect the vacuum hose to the fuel pressure regulator assembly.



2. INSPECT FOR FUEL LEAK
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON and turn the Techstream ON.

    NOTICE:
    Do not start the engine.

  1. Techstream:
    Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.

  1. Check that there are no fuel leaks after doing maintenance anywhere on the fuel system.



    A133618E01
  1. Check that the pulsation damper screw rises up when the fuel pump operates.
    If the operation is not as specified, check the following parts:

    1. Fusible link
    2. Fuses
    3. Circuit opening relay
    4. Fuel pump
    5. ECM
    6. Wiring connections
    If no malfunctions are found in the aforementioned components, replace the pulsation damper.

  1. Turn the ignition switch off.

  1. Disconnect the Techstream from the DLC3.