FUEL PRESSURE REGULATOR > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the 2 fuel pump ECU connectors.
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch off.
Crank the engine again, and then check that the engine does not start.
Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.
Connect the 2 fuel pump ECU connectors.
| 2. REMOVE V-BANK COVER |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 3. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum hose and ventilation hose.
Loosen the 2 clamps.
Remove the air cleaner hose.
| 4. REMOVE NO. 2 FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the No. 2 fuel tube from the fuel pressure regulator (Click here).
| 5. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY |
![]() |
Disconnect the vacuum sensing hose from the fuel pressure regulator.
![]() |
Remove the 2 bolts, and pull out the fuel pressure regulator.
Remove the O-ring from the pressure regulator.