Home › Engine / Hybrid System ยท 2UZ-FE › INTAKE / EXHAUST › EXHAUST PIPE

EXHAUST PIPE > REMOVAL

for Preparation Click here



1. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    A166393
  1. Remove the bolt and clamp.

  1. Disconnect the exhaust pipe support and remove the tail exhaust pipe assembly.

  1. Remove the gasket from the center exhaust pipe assembly.



2. REMOVE CENTER EXHAUST PIPE ASSEMBLY


    A166394
  1. Remove the 4 bolts.

  1. Disconnect the 3 exhaust pipe supports and remove the center exhaust pipe assembly.

  1. Remove the 2 gaskets from the front exhaust pipe assembly and front No. 3 exhaust pipe sub-assembly.



3. REMOVE FRONT EXHAUST PIPE ASSEMBLY


    A185584
  1. Disconnect the air fuel ratio sensor connector.



    A185585
  1. Disconnect the heated oxygen sensor connector and 2 clamps.



    A185586
  1. Remove the 3 nuts and remove the front exhaust pipe assembly.

  1. Remove the gasket form the front exhaust pipe assembly.



4. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A185587
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010  



5. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A185589
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  



6. REMOVE MONOLITHIC CONVERTER PROTECTOR


    A185591
  1. Remove the 4 bolts and 4 nuts, remove the monolithic converter protector and 4 converter protector stays.



7. REMOVE NO. 1 MONOLITHIC CONVERTER PROTECTOR


    A185592
  1. Remove the 4 bolts and 4 nuts, remove the No. 1 monolithic converter protector and 4 converter protector stays.



8. REMOVE FRONT NO. 3 EXHAUST PIPE SUB-ASSEMBLY


    A185593
  1. Remove the 2 bolts and 2 nuts.

  1. Disconnect the exhaust pipe support and remove the front No. 3 exhaust pipe sub-assembly.

  1. Remove the gasket from the front No. 2 exhaust pipe assembly.



9. REMOVE NO. 1 MONOLITHIC CONVERTER PROTECTOR


    A185594
  1. Remove the 4 bolts and 4 nuts, remove the No. 1 monolithic converter protector and 4 converter protector stays.



10. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY


    A185595
  1. Disconnect the air fuel ratio sensor connector.



    A185596
  1. Disconnect the heated oxygen sensor connector.



    A185602
  1. Remove the 3 nuts and remove the front No. 2 exhaust pipe assembly.



11. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    A185597
  1. Using SST, remove the air fuel ratio sensor.

    SST
    09224-00010  



12. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A185599
  1. Using SST, remove the heated oxygen sensor.

    SST
    09224-00010  



13. REMOVE MONOLITHIC CONVERTER PROTECTOR


    A185601
  1. Remove the 4 bolts and 4 nuts, remove the monolithic converter protector and 4 converter protector stays.