PROPELLER SHAFT ASSEMBLY (for 2WD) > REASSEMBLY |
| 1. INSTALL REAR PROPELLER SHAFT UNIVERSAL J0INT SPIDER |
![]() |
Apply MP grease to a new universal joint spider and universal joint spider bearings.
![]() |
Measure dimension A between the snap ring grooves.
Install the universal joint spider bearing into the universal joint spider and measure dimension B.
![]() |
Select hole snap rings of the correct thickness to make dimensions A and B the same.
| Color | Thickness |
| Purple | 1.46 mm (0.0574 in.) |
| Black | 1.49 mm (0.0586 in.) |
| Copper | 1.51 mm (0.0594 in.) |
| Black | 1.52 mm (0.0598 in.) |
| Black | 1.54 mm (0.0606 in.) |
| White | 1.56 mm (0.0614 in.) |
| Black | 1.57 mm (0.0618 in.) |
| Yellow | 1.59 mm (0.0625 in.) |
| Black | 1.62 mm (0.0638 in.) |
| Blue | 1.64 mm (0.0646 in.) |
Temporarily install the universal joint spider and 2 universal joint spider bearings into the universal joint sleeve yoke.
![]() |
Using SST, press the universal joint spider bearing into the universal joint sleeve yoke until the groove can be seen.
![]() |
Using needle-nose pliers, install a hole snap ring into the groove on the universal joint sleeve yoke.
Temporarily install the universal joint spider and 2 universal joint spider bearings into the propeller shaft's universal joint yoke.
![]() |
Using SST, press the universal joint spider bearing into the universal joint yoke until the groove can be seen.
![]() |
Using needle-nose pliers, install a hole snap ring into the groove on the universal joint yoke.
| 2. INSPECT UNIVERSAL JOINT SPIDER BEARING |
![]() |
Mount the propeller shaft in a vise.
Inspect the spider bearing for wear or damage.
Using a dial indicator, measure the spider bearing axial play by turning the yoke of the flange while holding the shaft tightly.