FRONT PROPELLER SHAFT ASSEMBLY > DISASSEMBLY |
| 1. INSPECT FRONT PROPELLER SHAFT ASSEMBLY |
![]() |
Check that the propeller shaft is not damaged or deformed.
Using a dial indicator, check the propeller shaft runout.
| 2. INSPECT UNIVERSAL JOINT SPIDER BEARING |
Check that the joints move smoothly.
Check the spider bearings for wear and damage.
Check the spider bearing axial play by turning the yoke while holding the shaft tightly.
| 3. REMOVE FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER |
![]() |
Place matchmarks on the universal joint flange yoke and propeller shaft's universal joint flange yoke.
![]() |
Using a brass bar and hammer, slightly tap in the universal joint spider bearing.
Using needle-nose pliers, remove the 4 hole snap rings from the grooves.
![]() |
Using SST, push out the universal joint spider bearing from the shaft's universal joint flange yoke.
![]() |
Clamp the universal joint spider bearing in a vise and tap off the propeller shaft with a hammer.
Install the 2 removed universal joint spider bearing to the universal joint spider.
![]() |
Using SST, push the universal joint spider bearing out of the universal joint flange yoke.
![]() |
Clamp the universal joint spider bearing in a vise and tap off the universal joint flange yoke with a hammer.
Remove the universal joint spider.