Home › Engine / Hybrid System ยท 2UZ-FE › ENGINE CONTROL › IGNITION COIL AND SPARK PLUG

IGNITION COIL AND SPARK PLUG > REMOVAL

for Preparation Click here



1. REMOVE THROTTLE BODY COVER ASSEMBLY


    A153486
  1. Remove the 2 nuts and throttle body cover sub-assembly.



2. REMOVE AIR CLEANER HOSE ASSEMBLY


    A153487
  1. Disconnect the vacuum hose and No. 2 ventilation hose.

  1. Loosen the 2 hose clamps and remove the air cleaner hose assembly.



3. REMOVE FRONT FENDER APRON SEAL LH


    A159336
  1. Remove the 5 clips and front fender apron seal LH.



4. REMOVE NO. 2 AIR HOSE


    A153515
  1. Disconnect the air switching valve assembly connector.

  1. Disconnect the fuel hose clamp.



    A153516
  1. Remove the No. 2 air hose.



5. REMOVE NO. 3 AIR TUBE


A153518
  1. Remove the 4 nuts, No. 3 air tube and 2 gaskets.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



6. REMOVE AIR SWITCHING VALVE ASSEMBLY (for Bank 1)


A153519E01
  1. Remove the 3 nuts and air switching valve assembly.

    NOTICE:
    Do not hold the bracket of the air switching valve assembly.



7. REMOVE FRONT FENDER APRON SEAL RH


    A159335
  1. Remove the 5 clips and front fender apron seal RH.



8. DISCONNECT NO. 1 WATER BY-PASS PIPE


    A159337
  1. Remove the 2 bolts and disconnect the No. 1 water by-pass pipe.

    NOTICE:
    Do not disconnect the hoses. If it is necessary to disconnect the hoses, first drain the engine coolant.



9. DISCONNECT NO. 2 AIR INJECTION SYSTEM HOSE
  1. Disconnect the No. 2 air injection system hose from the air switching valve assembly.



10. REMOVE NO. 2 AIR TUBE


    A153510
  1. Disconnect the air switching valve assembly connector.

  1. Disconnect the wire harness clamp.



    A153512
  1. Remove the 4 nuts, No. 2 air tube and 2 gaskets.

    NOTICE:
    Be careful not to damage the installation surface of the gaskets.



11. REMOVE AIR SWITCHING VALVE ASSEMBLY (for Bank 2)


    A153513E01
  1. Remove the 3 nuts and air switching valve assembly.

    NOTICE:
    Do not hold the bracket of the air switching valve assembly.



12. REMOVE IGNITION COIL ASSEMBLY


    A156195
  1. Disconnect the 8 ignition coil assembly connectors.

  1. Remove the 8 bolts and pull out the 8 ignition coil assemblies.



13. REMOVE SPARK PLUG
  1. Using a 16 mm plug wrench, remove the 8 spark plugs.