Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY

FRONT SEAT OUTER BELT ASSEMBLY > REMOVAL

for Preparation Click here


HINT:
  1. Use the same procedure for the LH side and RH side.
  2. The procedure listed below is for the LH side.



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
  1. After the ignition switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
  2. When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).



2. REMOVE FRONT SEAT ASSEMBLY LH (for Manual Seat)
  1. Remove the front seat assembly (Click here).



3. REMOVE FRONT SEAT ASSEMBLY LH (for Power Seat)
  1. Remove the front seat assembly (Click here ).



4. REMOVE FRONT DOOR SCUFF PLATE RH


    B190151
  1. Detach the 9 claws and remove the scuff plate.



5. REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH


    B191803
  1. Remove the front door opening trim weatherstrip.



6. REMOVE REAR FLOOR STEP NO. 1 COVER


    B191403E01
  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the cap.

    HINT:
    Use the same procedure for both sides.



7. REMOVE REAR DOOR SCUFF PLATE RH


    B186665
  1. Remove the bolt.

  1. Disengage the 5 clips and the 6 claws and 2 guides, and remove the rear door scuff plate front side.



    B186666
  1. Remove the 2 bolts.

  1. Disengage the 5 clips and the 2 claws, and remove the scuff plate rear side.



8. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP RH


    B191804
  1. Remove the rear door opening weatherstrip.



9. REMOVE LOWER CENTER PILLAR GARNISH RH


    B190128
  1. Disengage the 3 claws and remove the outer lap belt anchor cover.



    B190129
  1. Remove the bolt and the outer lap belt anchor.



    B190125
  1. Disengage the 7 clips and 2 claws, and remove the center pillar garnish.



10. REMOVE CENTER PILLAR GARNISH RH


  1. Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws and remove the 2 assist grip plugs.


    B190130E01

  1. Remove the 2 bolts and assist grip.

  1. Remove the bolt.

  1. Disengage the clip and guide.

  1. Pass the front seat outer belt floor anchor through the center pillar garnish, and remove the center pillar garnish.



11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    B194067
  1. Remove the nut and shoulder anchor.



    B194068E01
  1. Disconnect the pretensioner connector as shown in the illustration.



    B194070
  1. Remove the 2 bolts and front seat outer belt.



12. REMOVE FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    B194071
  1. Remove the 2 bolts and front seat shoulder belt anchor adjuster assembly.