Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING

SLIDING ROOF HOUSING > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here ).



2. REMOVE ROOF HEADLINING ASSEMBLY
  1. Remove the roof headlining (Click here).



3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH
  1. Remove the curtain shield airbag .



4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

HINT:
Use the same procedure for the RH side and LH side.



5. REMOVE SLIDING ROOF SIDE GARNISH RH


    B191412
  1. Disengage the 2 claws and the 3 guides, and remove the side garnish.



6. REMOVE SLIDING ROOF SIDE GARNISH LH

HINT:
Use the same procedure for the RH side and LH side.



7. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


B191413
  1. Using a "TORX" socket wrench T25, remove the 4 bolts and glass.



8. REMOVE SLIDING ROOF WEATHERSTRIP


    B191802
  1. Remove the sliding roof weatherstrip.



9. REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY
  1. Disconnect the 4 sliding roof drain hoses.



  1. Remove the 10 bolts, 6 nuts and housing.


    B191414