SLIDING ROOF HOUSING > REASSEMBLY |
| 1. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY |
Hold down the window deflector.

Slide the drive cable in the direction indicated by the arrow in the illustration to install it.
![]() |
Slide each roof wind deflector lifter link in the direction indicated by the arrow in the illustration to install it, and then engage the claw.
| 2. ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY |
![]() |
Using a screwdriver with its tip wrapped in protective tape, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.
| 3. INSTALL ROOF REAR DRIP CHANNEL |
Engage the 2 claws to install the drip channel.

| 4. INSTALL SUNSHADE TRIM SUB-ASSEMBLY |
![]() |
Insert the sunshade trim into the sliding roof housing.
![]() |
Install the sliding roof piece LH and RH.
Install the screw.
| 5. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
![]() |
Install the drive gear and room light bracket with the 2 bolts.
| 6. INSTALL SLIDING ROOF HOUSING REAR MOUNTING BRACKET RH |
![]() |
Install the rear mounting bracket with the 2 bolts.
| 7. INSTALL SLIDING ROOF HOUSING REAR MOUNTING BRACKET LH |