Home › Vehicle Exterior › WIPER / WASHER › WIPER SWITCH

WIPER SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY


    E146421
  1. Engage the claw and install the wiper switch.

  1. Connect the 2 connectors.



2. INSTALL UPPER STEERING COLUMN COVER


    E146420
  1. Engage the 4 clips to install the upper steering column cover onto the instrument panel cluster finish panel.

  1. Engage the claw to install the upper steering column cover.



3. INSTALL LOWER STEERING COLUMN COVER


    E146419
  1. Engage the 2 claws to install the lower steering column cover.

    NOTICE:
    Do not damage the tilt and telescopic switch.

  1. While turning the steering wheel to the right and left, install the 2 screws and the lower steering column cover.



4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B192333
  1. Engage the 2 claws and install the sensor.

  1. Connect the connectors.

  1. Engage the 4 clips and claw and install the finish panel.

  1. Install the 2 <A> bolts.



5. INSTALL INSTRUMENT SIDE PANEL LH


    B192332
  1. Engage the 4 guides and 3 claws and install the side panel.



6. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



7. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.