Home › Vehicle Exterior › WIPER / WASHER › WASHER NOZZLE

WASHER NOZZLE > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE WASHER NOZZLE SUB-ASSEMBLY
  1. Start the engine.



  1. Check that the center stream of washer fluid sprays on the windshield within the hatched areas shown in the illustration.

    Standard:
    Washer fluid hits the windshield in the areas shown in the illustration.




    1. Front:


      E161688E01

      Specification:
      Area
      Measurement
      A
      124 mm
      B
      34.1 mm
      C
      96.6 mm

      If the result is not as specified, replace the washer nozzle.



    2. Rear


      E162540E02

      Specification:
      Enter the target area.