STARTER > DISASSEMBLY |
| 1. REMOVE MAGNET STARTER SWITCH ASSEMBLY |
![]() |
Remove the nut, and disconnect the lead wire from the magnet starter switch.
![]() |
Remove the 2 nuts and magnet starter switch.
| 2. REMOVE STARTER DRIVE HOUSING ASSEMBLY |
![]() |
Using a T30 "TORX" socket wrench, remove the 2 bolts.
Pull out the yoke and the starter commutator end frame assembly together with the armature.
| 3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY |
![]() |
Remove the starter pinion drive lever.
![]() |
Remove the 2 screws and end frame.
| 4. REMOVE STARTER ARMATURE ASSEMBLY |
![]() |
Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.
Disconnect the 4 brushes and remove the brush holder.
![]() |
Remove the starter armature from the yoke.
| 5. REMOVE STARTER YOKE ASSEMBLY |
Remove the starter yoke from the starter center bearing clutch.
| 6. REMOVE STARTER ARMATURE PLATE |
![]() |
Remove the starter armature plate from the starter center bearing clutch.
| 7. REMOVE PLANETARY GEAR |
![]() |
Remove the 3 planetary gears.