Home › Engine / Hybrid System ยท 3UR-FBE › STARTING › STARTER

STARTER > DISASSEMBLY

for Preparation Click here



1. REMOVE MAGNET STARTER SWITCH ASSEMBLY


A162868
  1. Remove the nut, and disconnect the lead wire from the magnet starter switch.



    A162869
  1. Remove the 2 nuts and magnet starter switch.



2. REMOVE STARTER DRIVE HOUSING ASSEMBLY


A162870
  1. Using a T30 "TORX" socket wrench, remove the 2 bolts.

  1. Pull out the yoke and the starter commutator end frame assembly together with the armature.



3. REMOVE STARTER COMMUTATOR END FRAME ASSEMBLY


A162871
  1. Remove the starter pinion drive lever.



    A162872
  1. Remove the 2 screws and end frame.

    NOTICE:
    While holding down the lead wire, remove the starter commutator end frame.



4. REMOVE STARTER ARMATURE ASSEMBLY


A030137E02
  1. Using a screwdriver, hold the spring back and disconnect the brush from the brush holder.

  1. Disconnect the 4 brushes and remove the brush holder.



    A146942
  1. Remove the starter armature from the yoke.



5. REMOVE STARTER YOKE ASSEMBLY
  1. Remove the starter yoke from the starter center bearing clutch.



6. REMOVE STARTER ARMATURE PLATE


A149624
  1. Remove the starter armature plate from the starter center bearing clutch.



7. REMOVE PLANETARY GEAR


A146943
  1. Remove the 3 planetary gears.