ENGINE COOLANT TEMPERATURE SENSOR > REMOVAL |
| 1. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 3. REMOVE ENGINE COOLANT TEMPERATURE SENSOR |
![]() |
Disconnect the sensor connector.
Using a 19 mm ball joint lock nut wrench, remove the sensor.
Remove the gasket from the sensor.