Home › Engine / Hybrid System · 3UR-FE › ENGINE CONTROL › THROTTLE BODY

THROTTLE BODY > INSPECTION

for Preparation Click here



1. INSPECT THROTTLE W/MOTOR BODY ASSEMBLY
  1. Check the throttle valve.

    1. Check that the throttle valve opens and closes smoothly.

    2. Check that there is no sludge accumulating around the throttle W/ motor body.



    A163107E01
  1. Check the throttle control motor.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      1 (M-) - 2 (M+)
      20°C (68°F)
      0.3 to 100 Ω

      If the result is not as specified, replace the throttle W/ motor body.