Home › Engine / Hybrid System ยท 3UR-FE › ENGINE MECHANICAL › CYLINDER HEAD GASKET

CYLINDER HEAD GASKET > REMOVAL

for Preparation Click here



1. REMOVE EXHAUST MANIFOLD
  1. Remove the exhaust manifold (Click here).



2. REMOVE CAMSHAFT
  1. Remove the camshaft (Click here).



3. REMOVE NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
  1. Remove the 32 valve rocker arms from the cylinder head.

    HINT:
    Arrange the removed parts in the correct order.



4. REMOVE VALVE LASH ADJUSTER ASSEMBLY
  1. Remove the 32 valve lash adjusters from the cylinder head.

    HINT:
    Arrange the removed parts in the correct order.



5. REMOVE VALVE STEM CAP
  1. Remove the 32 valve stem caps from the cylinder head.

    HINT:
    Arrange the removed parts in the correct order.



6. REMOVE CYLINDER HEAD LH


    A160736E05
  1. Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.



    A160737E05
  1. Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.

    NOTICE:
    1. Be careful not to drop washers into the cylinder head.
    2. Head warpage or cracking could result from removing bolts in an incorrect order.

    HINT:
    Be sure to arrange the removed parts for each installation position separately.



7. REMOVE NO. 2 CYLINDER HEAD GASKET


8. REMOVE CYLINDER HEAD SUB-ASSEMBLY


    A160738E04
  1. Uniformly loosen and remove the 2 bolts in the sequence shown in the illustration.



    A160739E03
  1. Using a 10 mm bi-hexagon wrench, uniformly loosen the 10 cylinder head bolts in the sequence shown in the illustration. Remove the 10 cylinder head bolts and plate washers.

    NOTICE:
    1. Be careful not to drop washers into the cylinder head.
    2. Head warpage or cracking could result from removing bolts in an incorrect order.

    HINT:
    Be sure to arrange the removed parts for each installation position separately.



9. REMOVE CYLINDER HEAD GASKET