Home › Power Source / Network · NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2321    Driver Side Door ECU Communication Stop

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the front power window regulator motor assembly LH and main body ECU stops for 10 seconds or more.

DTC Code
DTC Detection Condition
Trouble Area
B2321
No communication between the front power window regulator motor assembly LH and main body ECU for 10 seconds or more.
  1. Front power window regulator motor assembly LH
  2. Main body ECU
  3. Harness or connector

WIRING DIAGRAM


E160670E02


INSPECTION PROCEDURE

NOTICE:
When using the Techstream with the ignition switch off to troubleshoot:
Connect the Techstream to the vehicle, and turn a courtesy switch on and off at 1.5 second intervals until communication between the Techstream and vehicle begins.

HINT:
  1. DTC B2325 is stored when the communication between the front power window regulator motor assembly LH and main body ECU stops.
  2. When DTC B1206 and B2321 are output simultaneously, perform the troubleshooting for DTC B1206 first (Click here).

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - REGULATOR MOTOR LH)


    E160671E01
  1. Disconnect the H2 main body ECU connector.

  1. Disconnect the M3 front power window regulator motor assembly LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H2-10 (LIN2) - M3-9 (LIN)
    Always
    Below 1 Ω

  1. Reconnect the main body ECU connector.

  1. Reconnect the front power window regulator motor assembly LH connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (REGULATOR MOTOR LH - BATTERY AND BODY GROUND)


    E160672E03
  1. Disconnect the M3 front power window regulator motor assembly LH connector.

  1. Measure the resistance and voltage according to the value(s) in the tables below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M3-1 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    M3-2 (B) - Body ground
    Always
    11 to 14 V

  1. Reconnect the front power window regulator motor assembly LH connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
  1. Temporarily replace the front power window regulator motor assembly LH with a new or normally functioning one (Click here).

  1. Clear the DTC (Click here).


NEXT


4.CHECK FOR DTC
  1. Recheck for DTCs (Click here).
    Result 
    Result
    Proceed to
    DTC B2321 is not output
    A
    DTC B2321 is output
    B



B
REPLACE MAIN BODY ECU
A

END (FRONT POWER WINDOW REGULATOR MOTOR LH IS DEFECTIVE)