DTC B2322 Front Passenger Side Door ECU Communication Stop |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2322 | No communication between the front power window regulator motor assembly RH and main body ECU for 10 seconds or more. |
|

| 1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - REGULATOR MOTOR RH) |
![]() |
Disconnect the H2 main body ECU connector.
Disconnect the L3 front power window regulator motor assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| H2-10 (LIN2) - L3-9 (LIN) | Always | Below 1 Ω |
Reconnect the main body ECU connector.
Reconnect the front power window regulator motor assembly RH connector.
|
| ||||
| OK | |
| 2.CHECK FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH (REGULATOR MOTOR RH - BATTERY AND BODY GROUND) |
![]() |
Disconnect the L3 front power window regulator motor assembly RH connector.
Measure the resistance and voltage according to the value(s) in the tables below.
| Tester Connection | Condition | Specified Condition |
| L3-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| L3-2 (B) - Body ground | Always | 11 to 14 V |
Reconnect the front power window regulator motor assembly RH connector.
|
| ||||
| OK | |
| 3.REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH |
Temporarily replace the front power window regulator motor assembly RH with a new or normally functioning one (Click here).
Clear the DTC (Click here).
| NEXT | |
| 4.CHECK FOR DTC |
Recheck for DTCs (Click here).
| Result | Proceed to |
| DTC B2322 is not output | A |
| DTC B2322 is output | B |
|
| ||||
| A | ||
| ||