COMBINATION METER > INSTALLATION |
| 1. INSTALL COMBINATION METER ASSEMBLY |
![]() |
Connect the connector and engage the clip and install the combination meter assembly.
![]() |
Install the 4 screws.
| 2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Engage the 12 clips and install the finish panel.
Connect the 2 connectors and clamp.
![]() |
Engage the 4 claws and install the instrument panel finish panel retainer.
| 3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY |
![]() |
Engage the 2 claws and install the sensor.
Connect the connectors.
Engage the 4 clips and claw and install the finish panel.
Install the 2 <A> bolts.
| 4. INSTALL INSTRUMENT SIDE PANEL LH |
![]() |
Engage the 4 guides and 3 claws and install the side panel.
| 5. INSTALL COWL SIDE TRIM BOARD LH |
| 6. INSTALL FRONT DOOR SCUFF PLATE LH |
| 7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 8. INSPECT SRS WARNING LIGHT |
Inspect the SRS warning light (Click here).