Home › Vehicle Interior › METER / GAUGE / DISPLAY › LIGHT CONTROL RHEOSTAT

LIGHT CONTROL RHEOSTAT > INSTALLATION

for Preparation Click here



1. INSTALL LIGHT CONTROL RHEOSTAT


    E141675
  1. Engage the 2 claws and install the light control rheostat.



2. INSTALL INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B192335
  1. Engage the 12 clips and install the finish panel.

  1. Connect the 2 connectors and clamp.



    B192334
  1. Engage the 4 claws and install the instrument panel finish panel retainer.



3. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B192333
  1. Engage the 2 claws and install the sensor.

  1. Connect the connectors.

  1. Engage the 4 clips and claw and install the finish panel.

  1. Install the 2 <A> bolts.



4. INSTALL INSTRUMENT SIDE PANEL LH


    B192332
  1. Engage the 4 guides and 3 claws and install the side panel.



5. INSTALL COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



6. INSTALL FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.