Home › Vehicle Interior › METER / GAUGE / DISPLAY › LIGHT CONTROL RHEOSTAT

LIGHT CONTROL RHEOSTAT > REMOVAL

for Preparation Click here



1. REMOVE FRONT DOOR SCUFF PLATE LH

HINT:
Use the same procedure for both sides.



2. REMOVE COWL SIDE TRIM BOARD LH

HINT:
Use the same procedure for both sides.



3. REMOVE INSTRUMENT SIDE PANEL LH


    B192331E01
  1. Apply protective tape, as shown in the illustration.

  1. Using a moulding remover, disengage the 3 claws and 4 guides and remove the side panel.



4. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH


B192333
  1. Remove the 2 <A> bolts.

  1. Disengage the 4 clips and claw.

  1. Disengage the 2 claws and separate the sensor.

  1. Disconnect the connectors and remove the finish panel.



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY


B192334
  1. Disengage the 4 claws and separate the instrument panel finish panel retainer.



    B192335
  1. Disconnect the 2 connectors and clamp.

  1. Disengage the 12 clips and remove the finish panel.



6. REMOVE LIGHT CONTROL RHEOSTAT


    E141675
  1. Disengage the 2 claws and remove the light control rheostat.